AT command problem under dc-unlocker

[userid63]

I've a Momodesign MD-@ HSUPA and unfortunately I digit AT^U2DIAG=267 under dc-unlocker program running. So now:

1) windows XP (sp3) see a Huawei network card then a USB modem;
2) dc-unlocker doesn't detect datacard therefore I can't use it and digit another AT command (for example AT^U2DIAG=255 to reset the key).

I tried to change firmware too.

What can I do?

[Vincentas]

You can try to use solution provided here:http://www.dc-unlocker.com/forum/showthread.php?t=1820

[userid63]

Sorry, not yet resolved problem.
Just a question: dc-unlocker can read only modem or network interface too?

[userid63]

You can try to use solution provided here:http://www.dc-unlocker.com/forum/showthread.php?t=1820

Unfortunately, I've just tryed to follow that way.

I think that I've a different problem: Franchino & Co. didn't see the modem for hardware/software conflicts. I think that my problem dipends on AT commands that have disabled the modem & activated a network interface.

In my opinion I need a kind of sotware that can read my datacard (like Mobile Partner that see a E180 Huawei while dc-unlocker can't do it) & permit to digit AT commands.

HELP ME

[Vincentas]

If there is no modem in device manager, then none of software can be used to enter AT command. Remove mass storage, if see in device manager. Try updating the driver from mobile partner or from dc-unlocker folder or from other place.